Instrument setup
R&S
®
RTP
110User Manual 1337.9952.02 ─ 12
Show labels
Switches the display of the mask test name on or off.
To change the name of the mask test, open the "Mask Test" dialog > "Define Mask"
tab. Double-tap the mask test subtab and enter the new mask test name.
Remote command:
MTESt:LABel on page 1177
MTESt:REName on page 1177
Show hits
If selected, the mask hits are highlighted on the screen. You can define the color and
the time of the hit display.
These settings are not applied to trigger zones, which are based on masks.
Remote command:
MTESt:HIGHlight:STATe on page 1178
Show for
Sets the time for which the mask hits are shown.
Remote command:
MTESt:HIGHlight:TIME on page 1178
Show hits forever
If selected, the mask hits are shown for an unlimited period of time.
Remote command:
MTESt:HIGHlight:INFinite on page 1177
Appearance settings
To Next Page
Loading...
