Rohde & Schwarz RTP044 - Page 1178

Remote control commands
R&S
®
RTP
1178User Manual 1337.9952.02 ─ 12
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
MTESt:HIGHlight:STATe <HighlightHits>
If ON, the mask hits are highlighted on the screen. You can define the color and the
time of the hit display.
Parameters:
<HighlightHits> ON | OFF
*RST: ON
Usage: Asynchronous command
MTESt:HIGHlight:TIME
<HighlightTime>
Sets the time how long the mask hits are highlighted.
Parameters:
<HighlightTime> Range: 0.05 to 50
Increment: 0.1
*RST: 1
Default unit: s
Usage: Asynchronous command
MTESt:COLor:UNMatch <ClrUnmatchedMsk>
Sets the color of masks segments that were not hit.
Parameters:
<ClrUnmatchedMsk> Decimal value corresponding to the ARGB hex value that is
shown in the "Color" dialog box. ARGB is a 32-bit unsigned inte-
ger with alpha, red, green, blue word order. Alpha defines the
transparency.
To get the value, covert the hex value from the dialog to decimal
value.
Range: 0 (black) to 4294967295 (white)
Increment: 1
*RST: 2578098858
Usage: Asynchronous command
MTESt:COLor:MATCh <ClrMatchedPixel>
Sets the color of samples that violated the mask.
Instrument setup