Remote control commands
R&S
®
RTP
1179User Manual 1337.9952.02 ─ 12
Parameters:
<ClrMatchedPixel> Decimal value corresponding to the ARGB hex value that is
shown in the "Color" dialog box. ARGB is a 32-bit unsigned inte-
ger with alpha, red, green, blue word order. Alpha defines the
transparency.
To get the value, covert the hex value from the dialog to decimal
value.
Range: 0 (black) to 4294967295 (white)
Increment: 1
*RST: 4294901760
Usage: Asynchronous command
MTESt:COLor:BORDer
<ClrMatchedMskBorder>
Sets the color of masks segments that were touched at the border. In this case, the
resolution is not sufficient to detect if the mask was really hit or not. Zoom into the con-
cerned area to see the actual result.
Parameters:
<ClrMatchedMskBorder>Decimal value corresponding to the ARGB hex value that is
shown in the "Color" dialog box. ARGB is a 32-bit unsigned inte-
ger with alpha, red, green, blue word order. Alpha defines the
transparency.
To get the value, covert the hex value from the dialog to decimal
value.
Range: 0 (black) to 4294967295 (white)
Increment: 1
*RST: 2580309606
Usage: Asynchronous command
MTESt:COLor:INTerior <ClrMatchedMskInterior>
Sets the color of mask segments the signal has entered into.
Parameters:
<ClrMatchedMskInterior>Decimal value corresponding to the ARGB hex value that is
shown in the "Color" dialog box. ARGB is a 32-bit unsigned inte-
ger with alpha, red, green, blue word order. Alpha defines the
transparency.
To get the value, covert the hex value from the dialog to decimal
value.
Range: 0 (black) to 4294967295 (white)
Increment: 1
*RST: 2578055168
Usage: Asynchronous command
Instrument setup
To Next Page
Loading...
