Rohde & Schwarz RTP044 - Page 1167

Remote control commands
R&S
®
RTP
1167User Manual 1337.9952.02 ─ 12
LAYout:SIGNal:UNASsign <Source>
Minimizes the specified waveform, i.e. removes it from the diagram and shows it in the
signal icon.
Setting parameters:
<Source> See LAYout:SIGNal:ASSign on page 1165 and Chap-
ter 22.4.2, "Waveform parameter", on page 1145
Example: See Chapter 22.3.1.1, "Creating diagrams (SmartGrid)",
on page 1127.
Usage: Setting only
Asynchronous command
22.7.2.5 Diagram appearance
DISPlay:DIAGram:TITLe...............................................................................................1167
DISPlay:SIGBar[:STATe]............................................................................................... 1167
DISPlay:GATE:TRANsparency...................................................................................... 1167
LAYout:ZOOM:ONEDiagram..........................................................................................1168
DISPlay:DIAGram:TITLe <DiagTitleSt>
If enabled, the tab titles of all diagrams are displayed: "Diagram1", "Diagram2" ...
If disabled, the tab titles are not shown except for those in a tabbed diagram. In tabbed
diagrams, the tab titles are required to change the tabs.
Parameters:
<DiagTitleSt> ON | OFF
Usage: Asynchronous command
DISPlay:SIGBar[:STATe] <State>
If enabled, the signal bar is displayed.
Parameters:
<State> ON | OFF
Usage: Asynchronous command
DISPlay:GATE:TRANsparency <Transparency>
Sets the transparency of the area that is defined as measurement or search gate.
Parameters:
<Transparency> Range: 0 to 100
Increment: 1
*RST: 43
Default unit: %
Instrument setup