Rohde & Schwarz RTP044 - Page 1173

Remote control commands
R&S
®
RTP
1173User Manual 1337.9952.02 ─ 12
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition? <LabelID>, <Source>
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition? <LabelID>, <Source>
Modifies or queries the absolute horizontal and vertical positiions of the specified label
if DISPlay:SIGNal:LABel:POSMode is set to ABS.
Parameters:
<Position> Range: Depends on waveform position and scaling
Default unit: s and V, or in other units depending on the wave-
form character
Parameters for setting and query:
<LabelID> String with the label identifier.
<Source> All waveforms that can be displayed, see DISPlay:SIGNal:
LABel:ADD
Example:
:DISPlay:SIGNal:LABel:POSMode C2W1, ABS
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition 'Label1', C2W1, 5e-09
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition 'Label1', C2W1, -0.1
Move the label to 5 ns and -0.1 V.
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition? <LabelID>, <Source>
DISPlay:SIGNal:LABel:VERTical:RELative:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:VERTical:RELative:POSition? <LabelID>, <Source>
Modifies or queries the relative horizontal and vertical positiions of the specified label if
DISPlay:SIGNal:LABel:POSMode is set to REL.
Parameters:
<Position> Position in percent of the screen counting from the upper left
corner.
Range: 0 to 100
Default unit: %
Parameters for setting and query:
<LabelID> String with the label identifier.
<Source> All waveforms that can be displayed, see DISPlay:SIGNal:
LABel:ADD
Instrument setup