Remote control commands
R&S
®
RTP
1222User Manual 1337.9952.02 ─ 12
Parameters:
<MeasMode> DMODe | CMODe | PMODe | NMODe
See PROBe<m>:SETup:PRMode on page 1218.
*RST: DMODe
Usage: Asynchronous command
PROBe<m>:DEEMbedding:TIPModule[:SELect] <ProbeTip>
Selects the tip module that is used for measurement.
Suffix:
<m>
.
1..4
Selects the channel to which the probe is connected.
Parameters:
<ProbeTip> NONE | ZMA10 | ZMA12 | ZMA14 | ZMA15 | ZMA30 | ZMA40 |
ZMA50 | CUST
*RST: ZMA10
Usage: Asynchronous command
PROBe<m>:DEEMbedding:TIPModule:CSPFile <SParamFile>
Sets the file name, file format and path of the S-parameter file, and loads the S-param-
eters of user-defined tip modules
Suffix:
<m>
.
1..4
Parameters:
<SParamFile> String with path, file name, and extension.
Usage: Asynchronous command
PROBe<m>:DEEMbedding:TIPModule:ZMA<n>:SUBModule <Value>
Defines additional settings for some tip modules:
For the browser module R&S RT-ZMA30, measure the space between the pins, and
select the appropriate value.
If R&S RT-ZMA40 is selected, choose the used submodule: semi-rigid cables or none.
Suffix:
<m>
.
1..4
Selects the channel to which the probe is connected.
<n> 30 (R&S RT-ZMA30) or 40 (R&S RT-ZMA40)
Parameters:
<Value> D16 | D25 | D45 | D75 | NONE | SRCS
For R&S RT-ZMA30:
Acquisition and setup
To Next Page
Loading...
