Rohde & Schwarz RTP044 - Page 1241

Remote control commands
R&S
®
RTP
1241User Manual 1337.9952.02 ─ 12
ZVC:Z<m>:I<n>:ZERComp:USE <UseZeroComp>
Enables the automatic compensation of the measured zero offset.
Suffix:
<m>
.
1..2
<n> 1..4
Parameters:
<UseZeroComp> ON | OFF
*RST: OFF
Usage: Asynchronous command
ZVC:Z<m>:I<n>:ZERComp:STATe?
Returns the status of the zero compensation of the indicated current channel.
Suffix:
<m>
.
1..2
<n> 1..4
Return values:
<ZeroCompState> ON | OFF
ON: Zero compensation is used
Off: Zero Compensation is not used
*RST: OFF
Usage: Query only
Asynchronous command
22.8.8.2 Resolution and data
ACQuire:POINts:ZVALue?............................................................................................ 1241
ACQuire:ZRESolution?.................................................................................................1242
ZVC:Z<m>:I<n>:DATA:HEADer?................................................................................... 1242
ZVC:Z<m>:V<n>:DATA:HEADer?.................................................................................. 1242
ZVC:Z<m>:I<n>:DATA[:VALues]?.................................................................................. 1242
ZVC:Z<m>:V<n>:DATA[:VALues]?................................................................................. 1242
ACQuire:POINts:ZVALue?
Returns the current record length used by the R&S RT-ZVCmulti-channel power probe
channel.
Return values:
<ZUIRecordLength> Range: 1000 to 400E6
Increment: 2
*RST: 1000
Default unit: pts
Acquisition and setup