Rohde & Schwarz RTP044 - Page 1312

Remote control commands
R&S
®
RTP
1312User Manual 1337.9952.02 ─ 12
TRIGger<m>:SEQuence:RESet:EVENt <EnabRstEvt>
If set to ON, the trigger sequence is restarted by the R-event if the specified number of
B-event does not occur.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
Parameters:
<EnabRstEvt> ON | OFF
*RST: OFF
Usage: Asynchronous command
TRIGger<m>:SEQuence:RESet:TIMeout[:ENABle]
<State>
If set to ON, the instrument waits for the time defined using TRIGger<m>:SEQuence:
RESet:TIMeout:TIME for the specified number of B-events. If no trigger occurs dur-
ing that time, the sequence is restarted with the A-event.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
TRIGger<m>:SEQuence:RESet:TIMeout:TIME <ResetTimeout>
The time the instrument waits for the number of B-events specified using
TRIGger<m>:SEQuence:COUNt before the sequence is restarted with the A-event.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
Parameters:
<ResetTimeout> Range: 0 to 50
Increment: 1E-12
*RST: 0
Default unit: s
Usage: Asynchronous command
Trigger