Remote control commands
R&S
®
RTP
1365User Manual 1337.9952.02 ─ 12
Protocol measurements
NONE | AUDio | F2F | F2A | FLDValue | GAP | MBITrate | SBI-
Trate | BIDLe | FCNT | FEC | FER | CFER
Requires option R&S RTP-K35
See Chapter 22.12.10, "Protocol", on page 1416
Example: See "Simple frequency and amplitude measurement"
on page 1128.
See "Creating and reading histograms" on page 1130
Usage: Asynchronous command
MEASurement<m>:ADDitional
<MeasType>, <State>
MEASurement<m>:ADDitional? <MeasType>
Adds additional measurements to the indicated measurement group. Only one mea-
surement can be enabled or disabled per command. The query returns the state of the
specified measurement.
Note that each measurement group must contain measurements from the same cate-
gory. For example, if the main measurement of measurement group 1 is amplitude,
then you cannot enable an eye width measurementin the same measurement group.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<State> ON | OFF
Enables or disables the measurement.
Parameters for setting and query:
<MeasType> See MEASurement<m>:MAIN on page 1364.
Usage: Asynchronous command
MEASurement<m>:AON
Enables all additional measurements in all categories of the indicated measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Usage: Event
Asynchronous command
MEASurement<m>:AOFF
Disables all additional measurements in all categories of the indicated measurement.
Automatic measurements
To Next Page
Loading...
