Remote control commands
R&S
®
RTP
1368User Manual 1337.9952.02 ─ 12
MEASurement<m>:RESult:WFMCount? [<MeasType>]
MEASurement<m>:RESult:STDDev? [<MeasType>]
Return the statistic results of the specified measurement. If no parameter is specified,
the result of the main measurement is returned. The main measurement is defined
using MEASurement<m>:MAIN.
●
[:ACTual]: current measurement result
●
AVG: average of the long-term measurement results
●
EVTCount: number of measurement results in the long-term measurement
●
NPEak: negative peak value of the long-term measurement results
●
PPEak: positive peak value of the long-term measurement results
●
RELiability: reliability of the measurement result
●
RMS: RMS value of the long-term measurement results
●
STDDev: standard deviation of the long-term measurement results
For a detailed description of the results see "Selection of the measurement group:
MEASurement<m>" on page 1359.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Query parameters:
<MeasType> Amplitude/time measurements
HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta |
MEAN | RMS | STDDev | POVershoot | NOVershoot | AREA |
RTIMe | FTIMe | PPULse | NPULse | PERiod | FREQuency |
PDCYcle | NDCYcle | CYCarea | CYCMean | CYCRms |
CYCStddev | PULCnt | DELay | PHASe | BWIDth | PSWitching |
NSWitching | PULSetrain | EDGecount | SETup | HOLD | SHR |
DTOTrigger | PROBemeter | SLERising | SLEFalling | ATAR
See Chapter 22.12.3, "Amplitude/time measurements",
on page 1370.
Jitter measurements (option R&S RTP-K12)
CCJitter | NCJitter | CCWidth | CCDutycycle | TIE | UINTerval |
DRATe | SKWDelay | SKWPhase
See Chapter 22.22.1, "Jitter measurements (option R&S RTP-
K12)", on page 2256
Eye diagram measurements
ERPercent | ERDB | EHEight | EWIDth | ETOP | EBASe | QFAC-
tor | RMSNoise | SNRatio | DCDistortion | ERTime | EFTime |
EBRate | EAMPlitude | PPJitter | STDJitter | RMSJitter
See Chapter 22.12.5, "Eye diagram measurements",
on page 1388.
Spectrum measurements
CPOWer | OBWidth | SBWidth | THD | THDPCT | THDA | THDU
| THDR | PLISt | HAR | THDF | SPAR
See Chapter 22.12.6, "Spectrum", on page 1391.
Automatic measurements
To Next Page
Loading...
