Rohde & Schwarz RTP044 - Page 1382

Remote control commands
R&S
®
RTP
1382User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<ArithCustomNmeSt> ON | OFF
*RST: OFF
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:CUUNit <ArithCustomUnit>
Sets a user-defined value of the unit for the amplitude/time arithmetic measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<ArithCustomUnit>
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:CUUState <ArithCustomUntSt>
Enables the use of user-defined custom unit for the amplitude/time arithmetic measure-
ment. You can set the unit with MEASurement<m>:AMPTime:ARIThmetic:CUUNit.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<ArithCustomUntSt> ON | OFF
*RST: OFF
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:OPERator <ArithOperator>
Selects the operation type to be performed on the selected operands for the amplitude/
time arithmetic measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Automatic measurements