Remote control commands
R&S
®
RTP
1411User Manual 1337.9952.02 ─ 12
MEASurement<m>:MULTiple <MultiMeas>
The measurement is performed repeatedly if the measured parameter occurs several
times inside the acquisition or defined gate.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<MultiMeas> ON | OFF
*RST: OFF
Usage: Asynchronous command
MEASurement<m>:MNOMeas <MaxMeasPerAcq>
Sets the maximum number of measurements per acquisition if repeated measurement
is enabled (MEASurement<m>:MULTiple is ON).
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<MaxMeasPerAcq> Range: 2 to 1000000
Increment: 1
*RST: 1000
Usage: Asynchronous command
MEASurement<m>:STATistics:HISTogram <ShowHistogram>
Displays a histogram of the statistical results. Enabling the histogram enables also the
calculation and display of statistics for the measurement results if statistics were dis-
abled. the histogram shows the cumulative occurence distribution of mean measure-
ment results in a graphic.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<ShowHistogram> ON | OFF
*RST: OFF
Usage: Asynchronous command
Automatic measurements
To Next Page
Loading...
