Rohde & Schwarz RTP044 - Page 1440

Remote control commands
R&S
®
RTP
1440User Manual 1337.9952.02 ─ 12
Usage: Asynchronous command
REFLevel<m>:ABSolute:BOTube <Value>
Defines an area beneath the low signal level which is still considered to be low level.
Suffix:
<m>
.
Valid suffix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 22.4.1,
"Waveform suffix", on page 1141.
Parameters:
<Value>
Usage: Asynchronous command
22.12.14.6 Results
MEASurement<m>:REFLevel:RESult:LOWer?................................................................1440
MEASurement<m>:REFLevel:RESult:MIDDle?............................................................... 1440
MEASurement<m>:REFLevel:RESult:UPPer?................................................................ 1440
MEASurement<m>:REFLevel:RESult:SIGLow?.............................................................. 1440
MEASurement<m>:REFLevel:RESult:SIGHigh?..............................................................1440
MEASurement<m>:REFLevel:RESult:BINNer?............................................................... 1441
MEASurement<m>:REFLevel:RESult:BOUTer?.............................................................. 1441
MEASurement<m>:REFLevel:RESult:TINNer?............................................................... 1441
MEASurement<m>:REFLevel:RESult:TOUTer?...............................................................1442
MEASurement<m>:REFLevel:RESult:LOWer?
MEASurement<m>:REFLevel:RESult:MIDDle?
MEASurement<m>:REFLevel:RESult:UPPer?
Return the lower, middle, and upper reference level, respectively.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Return values:
<Upper> Range: -100E+24 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MEASurement<m>:REFLevel:RESult:SIGLow?
MEASurement<m>:REFLevel:RESult:SIGHigh?
Return the signal value that represents a low or high level, respectively.
Automatic measurements