Rohde & Schwarz RTP044 - Page 1475

Remote control commands
R&S
®
RTP
1475User Manual 1337.9952.02 ─ 12
The value is useful if you test a specified number of acquisitions with action "Stop
acquisition" on violation, or if the acquisition has been stopped manually.
Query parameters:
<MaskTestName>
Return values:
<AcqsRemaining> Range: 0 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MTESt:RESult:COUNt:FWAVeforms?
<MaskTestName>
Returns the number of acquisitions that contained at least one sample hit.
Query parameters:
<MaskTestName>
Return values:
<AcquisitionHits> Range: 0 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MTESt:RESult:COUNt:FAILures? <MaskTestName>
Returns the number of sample hits that violated the mask.
Query parameters:
<MaskTestName>
Return values:
<SampleHits> Range: 0 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MTESt:RESult:FRATe? <MaskTestName>
Ratio of acquisition hits to the number of tested acquisitions.
Query parameters:
<MaskTestName>
Return values:
<FailRate> Range: -100E+24 to 100E+24
*RST: 0
Default unit: %
Mask testing