Rohde & Schwarz RTP044 - Page 1474

Remote control commands
R&S
®
RTP
1474User Manual 1337.9952.02 ─ 12
MTESt:RESult:STATe? <MaskTestName>
Shows if the test is running or has finished. The state is set to "Finished" if no acquisi-
tions remain (see MTESt:RESult:COUNt:REMaining? on page 1474).
Query parameters:
<MaskTestName>
Return values:
<State> RUNNing | FINished
*RST: RUNNing
Usage: Query only
Asynchronous command
MTESt:RESult[:RESult]?
<MaskTestName>
Returns the test result.
A test has failed if the number of sample hits or acquisition hits exceeds the limit of
"Violation tolerance" hits (see MTESt:TOLerance on page 1461, MTESt:RESult:
COUNt:FAILures? on page 1475 and MTESt:RESult:COUNt:FWAVeforms?
on page 1475).
Query parameters:
<MaskTestName>
Return values:
<TestResult> PASS | FAIL
*RST: PASS
Usage: Query only
Asynchronous command
MTESt:RESult:COUNt:WAVeforms? <MaskTestName>
Returns the number of tested acquisitions.
Query parameters:
<MaskTestName>
Return values:
<AcqsCompleted> Range: 0 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MTESt:RESult:COUNt:REMaining? <MaskTestName>
Remaining acquisitions until "Average count / Nx Single count" is reached.
Mask testing