Rohde & Schwarz RTP044 - Page 1481

Remote control commands
R&S
®
RTP
1481User Manual 1337.9952.02 ─ 12
SEARch:SOURce........................................................................................................ 1481
SEARch:ONLine.......................................................................................................... 1482
SEARch:ALL............................................................................................................... 1482
SEARch:ADD <SearchName>
Creates a new search definition with the specified name.
Setting parameters:
<SearchName> String with the name of the search
Example: See Chapter 22.3.4.1, "Searching for a pulse of specified width",
on page 1132
Usage: Setting only
Asynchronous command
SEARch:CLEar <SearchName>
Clears the search results once to start a new search.
Setting parameters:
<SearchName> Search definition
Usage: Setting only
Asynchronous command
SEARch:REMove <Key>
Deletes the specified search definition.
Setting parameters:
<Key> String with the name of the search
Usage: Setting only
Asynchronous command
SEARch:SOURce <SearchName>,<Source>
SEARch:SOURce? <SearchName>
Defines the source on which the search conditions are applied. The source can be any
analog or digital channel, math or reference waveform as well as a serial bus config-
ured for a supported protocol.
Search