Rohde & Schwarz RTP044 - Page 1510

Remote control commands
R&S
®
RTP
1510User Manual 1337.9952.02 ─ 12
Parameters:
<RelativeStart> Range: 0 to 100
Increment: 0.1
*RST: 0
Default unit: %
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:RELative:STOP <SearchName>,<RelativeStop>
SEARch:GATE:RELative:STOP? <SearchName>
Defines the end value for the gate.
Parameters:
<RelativeStop> Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:ZCOupling <SearchName>,<ZoomCoupling>
SEARch:GATE:ZCOupling? <SearchName>
If enabled, the gate area is set to the limits of a zoom area.
The zoom diagramm is selected using SEARch:GATE:ZDIagram.
Parameters:
<ZoomCoupling> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> String with the name of the search
Usage: Asynchronous command
SEARch:GATE:ZDIagram <SearchName>, <DiagramName>, <ZoomName>
SEARch:GATE:ZDIagram? <SearchName>
Selects the zoom to which the gate area is set if SEARch:GATE:ZCOupling is set to
"ON".
Parameters:
<ZoomDiagram> String with the name of the diagram, where the zoom is defined
Parameters for setting and query:
<SearchName> String with the name of the search
Search