Rohde & Schwarz RTP044 - Page 1613

Remote control commands
R&S
®
RTP
1613User Manual 1337.9952.02 ─ 12
22.17.5.3 Decode results
BUS<m>:UART:WORD<n>:RXValue?............................................................................1613
BUS<m>:UART:WORD<n>:TXValue?............................................................................ 1613
BUS<m>:UART:WORD<n>:BITRate?............................................................................ 1613
BUS<m>:UART:WORD<n>:COUNt?..............................................................................1613
BUS<m>:UART:WORD<n>:SOURce?............................................................................1614
BUS<m>:UART:WORD<n>:STARt?............................................................................... 1614
BUS<m>:UART:WORD<n>:STATe?............................................................................... 1614
BUS<m>:UART:WORD<n>:RXValue?
BUS<m>:UART:WORD<n>:TXValue?
Returns the value of the specified word on the Rx line or Tx line, respectively.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the word.
Return values:
<Value> To set the value format, use FORMat:BPATtern.
The stated values for range, increment and reset are decimal
values.
Range: 0 to 511
*RST: 0
Usage: Query only
BUS<m>:UART:WORD<n>:BITRate?
Returns the primary bit rate.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
The suffix is irrelevant.
Return values:
<PrimaryBitRate> Range: 0 to 100000000000
Increment: 1
*RST: 0
Default unit: bps
Usage: Query only
BUS<m>:UART:WORD<n>:COUNt?
Returns the number of words in the acquisition.
Protocols