Remote control commands
R&S
®
RTP
1662User Manual 1337.9952.02 ─ 12
Parameters:
<DataPatternTo> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:LIN:BORDer <Endianness>
Sets the byte order (endianness) of the data transfer.
According to the standard, LIN data is transmitted in little endian transfer order.
Parameters:
<Endianness> BENDian | LENDian
BENDian
Big endian, data is analyzed and evaluated in the order of
reception.
LENDian
Little endian, the instrument reads the complete data, reverses
the byte order of the data, and compares it with the specified
data word.
*RST: BENDian
TRIGger<m>:LIN:DLECondition <DLCOperator>
Operator to set the data length for triggering on LIN data.
For Big Endian transfer direction, you can trigger on a number of bytes less than the
data length of the frame, that means, on the first bytes that are transmitted. For Little
Endian transfer direction, the exact number of data bytes in the frame must be set.
Example: The data word to be sent is 12 34 56, and it is sent little endian by the LIN
node. With Data length ≥ 2 and Transfer = Big endian, you trigger on the data of the
first two bytes, that is 56 34. With Data length = 3 and Transfer = Little endian, you trig-
ger on the required data word 12 34 56.
The number of data bytes to be found is set with TRIGger<m>:LIN:DLENgth
on page 1662.
See also:TRIGger<m>:LIN:BORDer on page 1662 .
Parameters:
<DLCOperator> EQUal | GETHan
For little endian transfer direction, EQUal must be set.
*RST: GETHan
TRIGger<m>:LIN:DLENgth <WordCount>
Sets the length of the bit pattern to be found, in bytes. For "Big Endian" transfer direc-
tion, you can trigger on a number of bytes less than the data length of the frame, that
means, on the beginning of the data pattern. For "Little Endian" transfer direction, the
exact number of data bytes in the frame must be set.
Protocols
To Next Page
Loading...
