Remote control commands
R&S
®
RTP
1674User Manual 1337.9952.02 ─ 12
Parameters:
<IdentifierData> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:SERRor <SearchName>,<ErrorCondition>
SEARch:TRIGger:LIN:SERRor? <SearchName>
Enables the search for various errors in the frame.
Parameters:
<ErrorCondition> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:WUFRame <SearchName>,<WakeUpFrame>
SEARch:TRIGger:LIN:WUFRame? <SearchName>
Enables the search for wakeup frames.
Parameters:
<WakeUpFrame> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:ICONdition <SearchName>,<IdOperator>
SEARch:TRIGger:LIN:ICONdition? <SearchName>
Sets the operator to define a specific identifier or an identifier range.
Parameters:
<IdOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These operators require one identifier
pattern to be set with SEARch:TRIGger:LIN:IMIN
INRange | OORange
In range / Out of range: Set the minimum and maximum value of
the range with SEARch:TRIGger:LIN:IMIN and SEARch:
TRIGger:LIN:IMAX.
*RST: EQUal
Protocols
To Next Page
Loading...
