Rohde & Schwarz RTP044 - Page 1673

Remote control commands
R&S
®
RTP
1673User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:LIN:DLENgth.....................................................................................1678
SEARch:TRIGger:LIN:IPERror...................................................................................... 1678
SEARch:TRIGger:LIN:SYERror..................................................................................... 1678
SEARch:TRIGger:LIN:CHKSerror..................................................................................1678
SEARch:TRIGger:LIN:ERRPattern.................................................................................1679
SEARch:TRIGger:LIN:CRCDatalen................................................................................1679
SEARch:TRIGger:LIN:STANdard...................................................................................1679
SEARch:TRIGger:LIN:SSOFrame <SearchName>,<FrameStart>
SEARch:TRIGger:LIN:SSOFrame? <SearchName>
Enables the search for the stop bit of the sync field, which marks the frame start.
Parameters:
<FrameStart> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:SFIDentifier <SearchName>,<Identifier>
SEARch:TRIGger:LIN:SFIDentifier? <SearchName>
Enables the search for one specific identifier or an identifier range.
Parameters:
<Identifier> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:IDENtifieror <SearchName>,<IdentifierOr>
SEARch:TRIGger:LIN:IDENtifieror? <SearchName>
Enables the search for one to four address conditions.
Parameters:
<IdentifierOr> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:SIDData <SearchName>,<IdentifierData>
SEARch:TRIGger:LIN:SIDData? <SearchName>
Enables the search for a combination of identifier and data conditions.
Protocols