Remote control commands
R&S
®
RTP
1693User Manual 1337.9952.02 ─ 12
*RST: EQUal
TRIGger<m>:MILStd:CDST:IMAX <InfoPatternMax>
Sets the end value of the info range if TRIGger<m>:MILStd:CDST:ICONdition is
set to INRange.
Parameters:
<InfoPatternMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CDST:IMIN
<InfoPatternMin>
Specifies an info or sets the the start value of an info range.
Parameters:
<InfoPatternMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:DATA:DCONdition <DataOperator>
Sets the operator to set a specific data pattern.
Parameters:
<DataOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with TRIGger<m>:MILStd:DATA:DMIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:MILStd:DATA:DMIN and
TRIGger<m>:MILStd:DATA:DMAX.
*RST: EQUal
TRIGger<m>:MILStd:DATA:DMAX <DataPatternMax>
Sets the end value of a data pattern range if TRIGger<m>:MILStd:DATA:
DCONdition is set to INRange or OORange.
Parameters:
<DataPatternMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Protocols
To Next Page
Loading...
