Rohde & Schwarz RTP044 - Page 1697

Remote control commands
R&S
®
RTP
1697User Manual 1337.9952.02 ─ 12
TRIGger<m>:MILStd:STATus:INSTrument <InstFlag>
Triggers on the state of the instrumentation bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<InstFlag> ONE | ZERO | DC
*RST: ZERO
TRIGger<m>:MILStd:STATus:MERRor <MessageError>
Triggers on the state of the message error bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<MessageError> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:SREQuest
<ServiceRequest>
Triggers on the state of the the service request bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<ServiceRequest> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:SUBSystem <SubsystemFlag>
Triggers on the state of the subsystem flag bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<SubsystemFlag> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:TERMinal <TerminalFlag>
Triggers on the state of theterminal flag bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<TerminalFlag> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:TPSPecifier <TypeSpecifier>
Sets the sync impulse/ word type to be triggered on.
Protocols