Rohde & Schwarz RTP044 - Page 1713

Remote control commands
R&S
®
RTP
1713User Manual 1337.9952.02 ─ 12
Parameters:
<MinGapBits> Range: 0 to 100
Increment: 1
*RST: 4
Default unit: bit
BUS<m>:ARINc:POLarity <Polarity>
Sets the wire on which the bus signal is measured.
Suffix:
<m>
.
1..4
Parameters:
<Polarity> ALEG | BLEG
*RST: ALEG
BUS<m>:ARINc:PRESet <Preset>
Sets the default threshold voltage.
Suffix:
<m>
.
1..4
Parameters:
<Preset> V25 | V5 | MANual
*RST: V5
BUS<m>:ARINc:THReshold:HIGH <ThresholdHigh>
Sets the high threshold level of the signal.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdHigh> Range: 0 to 12
Increment: 0.1
*RST: 5
Default unit: V
BUS<m>:ARINc:THReshold:LOW <ThresholdLow>
Sets the low threshold level of the signal.
Suffix:
<m>
.
1..4
Protocols