Rohde & Schwarz RTP044 - Page 1731

Remote control commands
R&S
®
RTP
1731User Manual 1337.9952.02 ─ 12
*RST: STARt
TRIGger<m>:ETHernet:PATTern <DataPattern>
Specifies the bit pattern (or data) that is to be triggered.
Suffix:
<m>
.
1..3
Parameters:
<DataPattern>
TRIGger<m>:ETHernet:ERRor:CRC
<ErrorCRC>
Enables the trigger on a mismatch of the cyclic redundancy check (CRC) value
between the transmitting and receiving device.
Suffix:
<m>
.
1..3
Parameters:
<ErrorCRC> ON | OFF
*RST: ON
TRIGger<m>:ETHernet:ERRor:LENGth <ErrorLength>
Enables the trigger on an incorrect length of the sequence - when additional or missing
bits are detected and the sequence of bits is not as expected.
Suffix:
<m>
.
1..3
Parameters:
<ErrorLength> ON | OFF
*RST: ON
TRIGger<m>:ETHernet:ERRor:PREamble <ErrorPreamble>
Enables the trigger on a frame with invalid preamble.
Suffix:
<m>
.
1..3
Parameters:
<ErrorPreamble> ON | OFF
*RST: ON
TRIGger<m>:ETHernet:FRAMe:CCONdition <CRCOperator>
Sets the operator to trigger on a specific frame check sequence value.
Protocols