Remote control commands
R&S
®
RTP
1801User Manual 1337.9952.02 ─ 12
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:DATA:DMIN <SearchName>,<DataMin>
SEARch:TRIGger:TBTO:DATA:DMIN? <SearchName>
Specifies the data bit pattern, or sets the start value of a pattern range.
Parameters:
<DataMin> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (do not care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:DATA:ICONdition <SearchName>,<DataIdxOperator>
SEARch:TRIGger:TBTO:DATA:ICONdition? <SearchName>
Sets the search condition for the index. You can define an exact value or a value
range.
Parameters:
<DataIdxOperator> EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:TBTO:
DATA:IMIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:TBTO:DATA:IMIN and
SEARch:TRIGger:TBTO:DATA:IMAX.
*RST:
INRange
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:DATA:IMAX <SearchName>,<DataIndexMax>
SEARch:TRIGger:TBTO:DATA:IMAX? <SearchName>
Sets the end value of the index range to be searched for, if SEARch:TRIGger:TBTO:
DATA:IMAX is set to INRange or OORange.
Parameters:
<DataIndexMax> Range: 1 to 0
Increment: 1
*RST: 0
Protocols
To Next Page
Loading...
