Remote control commands
R&S
®
RTP
1803User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:TBTO:ERRor:ZERO <SearchName>,<ErrorZERO>
SEARch:TRIGger:TBTO:ERRor:ZERO? <SearchName>
Enables search for zero ternary symbol pairs error.
Parameters:
<ErrorZERO> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:LENGth:CONDition
<SearchName>,<TypeOperator>
SEARch:TRIGger:TBTO:LENGth:CONDition? <SearchName>
Sets the condition for the length/ type. You can define an exact value or a value range.
Parameters:
<TypeOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, not equal, less than, less or equal than, greater than,
greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:TBTO:
LENGth:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:TBTO:LENGth:MIN and
SEARch:TRIGger:TBTO:LENGth:MAX.
*RST:
EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:LENGth:MAX <SearchName>,<TypePatternMax>
SEARch:TRIGger:TBTO:LENGth:MAX? <SearchName>
Sets the end value of the length / type range if SEARch:TRIGger:TBTO:LENGth:
CONDition is set to INRange or OORange.
Parameters:
<TypePatternMax>
Parameters for setting and query:
<SearchName> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (do not care).
Protocols
To Next Page
Loading...
