Rohde & Schwarz RTP044 - Page 1845

Remote control commands
R&S
®
RTP
1845User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<DispDatVect> ON | OFF
*RST: OFF
BUS<m>:DPHY:THCoupling <ThresCpl>
Enables coupling, i.e. the same threshold and hysteresis value is used for all lanes.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ThresCpl> ON | OFF
*RST: ON
BUS<m>:DPHY:THPReset <ThresholdPreset>
Prests the threshold and hysteresis values of the high speed data lanes. A preset sets
the low power threshold to 1.20V and high speed threshold to 200 mV.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ThresholdPreset> LPHS | MANual
*RST: LPHS
BUS<m>:DPHY:VARiant <ProtSel>
Selects the protocol running on the interface.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ProtSel> DSI | CSI2
*RST: CSI2
BUS<m>:DPHY:DNZero:LPOWer:THUPper <ThresLPDN0High>
BUS<m>:DPHY:DPZero:LPOWer:THUPper <ThresLPDP0High>
Sets the upper threshold value for the respective lane used for the low power mode.
Protocols