Rohde & Schwarz RTP044 - Page 1876

Remote control commands
R&S
®
RTP
1876User Manual 1337.9952.02 ─ 12
BUS<m>:MPHY:THCoupling <Coupling>
Enables the same threshold value to be used for all lanes.
When the threshold coupling is disabled, changes to the threshold value only affect the
respective lane.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Coupling> ON | OFF
*RST: ON
BUS<m>:MPHY:THPReset <ThresholdPreset>
Selects the predefined value to preset the threshold value of the data lanes.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ThresholdPreset> THRES_60MV | THRES_120MV | THRES_240MV | MANual
THRES_60MV | THRES_120MV | THRES_240MV
Sets the threshold value of the data lane to the selected prede-
fined value.
MANual
Automatically switches to this option if you edit the threshold text
box manually.
*RST: MANual
BUS<m>:MPHY:SCRMode <SSICScrambleMd>
Sets if the SSIC data is scrambled or unscrambled.
Suffix:
<m>
.
1..4
Parameters:
<SSICScrambleMd> SCRM | NSCR
SCRM: scrambled
NSCR: unscrambled
*RST: SCRM
BUS<m>:MPHY:SMLanes <Active>
Enables the display of the results in multiple lanes.
Protocols