Rohde & Schwarz RTP044 - Page 1892

Remote control commands
R&S
®
RTP
1892User Manual 1337.9952.02 ─ 12
Parameters:
<ErrorLength> ON | OFF
*RST: ON
TRIGger<m>:MPHY:ERRor:REServed <ErrorReserved>
Enables/disables trigger on reserved bit error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorReserved> ON | OFF
*RST: ON
TRIGger<m>:MPHY:ERRor:SYMBol
<ErrorSymbol>
Enables/disables trigger on 8b10b symbol error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorSymbol> ON | OFF
*RST: ON
TRIGger<m>:MPHY:ERRor:UNKNown <ErrorUnknown>
Enables/disables trigger on unidentified UniPro frame error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorUnknown> ON | OFF
*RST: ON
22.17.15.3 Decode results M-PHY
To show the results on the screen, use the following commands:
●
BUS<m>:RESult on page 1549
BUS<m>:MPHY:RESult:FRAMe<n>:FTYPe?..................................................................1893
BUS<m>:MPHY:RESult:FRAMe<n>:STATe?...................................................................1894
BUS<m>:MPHY:RESult:FCOunt?..................................................................................1894
BUS<m>:MPHY:RESult:FRAMe<n>:CCOunt?................................................................ 1895
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:DATA?..................................................... 1895
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:STARt?....................................................1895
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:STOP?.....................................................1896
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:STATe?....................................................1896
Protocols