Rohde & Schwarz RTP044 - Page 2108

Remote control commands
R&S
®
RTP
2108User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
Parameters:
<SourceStrobe> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
*RST: C2W1
BUS<m>:SWIRe:STRBe:THReshold <ThresholdStrobe>
Sets the threshold value for the digitization of the strobe signal.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdStrobe> Range: -10 to 10
Increment: 0.1
*RST: 1.25
Default unit: V
BUS<m>:SWIRe:SYSLect <SyncSelector>
Selects the mode for the synchronisation settings, i.e i.e. packet align.
Suffix:
<m>
.
1..4
Parameters:
<SyncSelector> AUTO | MANual
*RST: AUTO
BUS<m>:SWIRe:COUPling <ThresCpl>
Enables coupling, i.e. the same threshold and hysteresis value is used for the strob
and the data signal.
Suffix:
<m>
.
1..4
Parameters:
<ThresCpl> ON | OFF
*RST: ON
BUS<m>:SWIRe:PRESet <ThresholdPreset>
Prests the threshold and hysteresis value of the strobe and data signal.
Protocols