Rohde & Schwarz RTP044 - Page 2109

Remote control commands
R&S
®
RTP
2109User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
Parameters:
<ThresholdPreset> V25 | V165 | V125 | V09 | V12 | V0 | MANual
V25: 2.5 V (CMOS 5.0 V)
V165: 1.65 V (CMOS 3.5 V)
V125: 1.25 V (CMOS 1.5 V)
V09: 2.5 V (CMOS 1.8V)
V12: 1.2 V (LVDS single ended)
V0: 0 V (LVDS differential)
MANual: user-defined value
*RST: V12
22.17.22.2
Trigger
TRIGger<m>:SWIRe:CTYPe.........................................................................................2109
TRIGger<m>:SWIRe:DATA:CONDition...........................................................................2109
TRIGger<m>:SWIRe:DATA:MAX................................................................................... 2110
TRIGger<m>:SWIRe:DATA:MIN.....................................................................................2110
TRIGger<m>:SWIRe:ERRor:ESC.................................................................................. 2110
TRIGger<m>:SWIRe:ERRor:PARity................................................................................2111
TRIGger<m>:SWIRe:TIME:CONDition............................................................................2111
TRIGger<m>:SWIRe:TIME:MAX.................................................................................... 2111
TRIGger<m>:SWIRe:TIME:MIN..................................................................................... 2111
TRIGger<m>:SWIRe:TYPE........................................................................................... 2112
TRIGger<m>:SWIRe:CTYPe <ControlType>
Triggers on a specific control type character.
Suffix:
<m>
.
1..3
Parameters:
<ControlType> ANY | FCT | EOP | EEP
FCT
Flow Control Token
EOP
Normal End of Packet
EEP
Error End of Packet
*RST: ANY
TRIGger<m>:SWIRe:DATA:CONDition <DataOperator>
Set the condition for the data value. You can define an exact value or a value range.
Protocols