Remote control commands
R&S
®
RTP
2120User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:SWIRe:TIME:MAX <SearchName>,<TimePatternMax>
SEARch:TRIGger:SWIRe:TIME:MAX? <SearchName>
Sets the the end value of a data type range for the time code if SEARch:TRIGger:
SWIRe:TIME:CONDition is set to INRange or OORange.
Parameters:
<TimePatternMax>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SWIRe:TIME:MIN <SearchName>,<TimePatternMin>
SEARch:TRIGger:SWIRe:TIME:MIN? <SearchName>
Specifies a data bit pattern for the time code, or sets the the start value of a pattern
range.
Parameters:
<TimePatternMin>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SWIRe:TYPE <SearchName>,<Type>
SEARch:TRIGger:SWIRe:TYPE? <SearchName>
Sets the search type for the SpaceWire analysis.
Parameters:
<Type> CTRL | DATA | NULL | TIME | ERRor
*RST: CTRL
Parameters for setting and query:
<SearchName>
22.17.22.5 Search results
In all SEARch:RESult:DPHY:FRAMe<m> commands, the suffix <m> selects the frame
number in the list of search results.
SEARch:RESult:SWIRe:FCOunt?..................................................................................2120
SEARch:RESult:SWIRe:FRAMe<m>:DATA?...................................................................2121
SEARch:RESult:SWIRe:FRAMe<m>:STARt?..................................................................2121
SEARch:RESult:SWIRe:FRAMe<m>:STATe?..................................................................2121
SEARch:RESult:SWIRe:FRAMe<m>:STOP?..................................................................2122
SEARch:RESult:SWIRe:FRAMe<m>:TYPE?.................................................................. 2122
SEARch:RESult:SWIRe:FCOunt? <SearchName>
Returns the number of frames within the search result for the selected serial bus.
Protocols
To Next Page
Loading...
