Remote control commands
R&S
®
RTP
2161User Manual 1337.9952.02 ─ 12
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:TLP:REID <SearchName>,<TLPRequesterID>
SEARch:TRIGger:PCIE:TLP:REID? <SearchName>
Sets the requester ID to be searched for in the transaction layer type.
Parameters:
<TLPRequesterID> 16-bit pattern, see Chapter 22.4.6, "Bit pattern parameter",
on page 1148. The string parameter accepts the bit value X
(don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:TLP:SNOO <SearchName>,<Snoop>
SEARch:TRIGger:PCIE:TLP:SNOO? <SearchName>
Sets the snoop state to be searched for in the transaction layer type.
Parameters:
<Snoop> ANY | YES | NO
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:TLP:SNUM <SearchName>,<TLPSeqNo>
SEARch:TRIGger:PCIE:TLP:SNUM? <SearchName>
Sets the sequence numbe to be searched for in the transaction layer type.
Parameters:
<TLPSeqNo> 12-bit pattern, see Chapter 22.4.6, "Bit pattern parameter",
on page 1148. The string parameter accepts the bit value X
(don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:TLP:TCHN <SearchName>,<TrafficClass>
SEARch:TRIGger:PCIE:TLP:TCHN? <SearchName>
Sets the traffic class to be searched for in the transaction layer type.
Parameters:
<TrafficClass> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN
*RST: ANY
Protocols
To Next Page
Loading...
