Rohde & Schwarz RTP044 - Page 2184

Remote control commands
R&S
®
RTP
2184User Manual 1337.9952.02 ─ 12
SEARch:RESult:DDR:FRAMe<m>:STOP? <SearchName>
Returns the stop time of the frame with the selected frame number within the search
result.
Suffix:
<m>
.
*
Query parameters:
<SearchName>
Return values:
<Stop> Range: -100E+24 to 100E+24
Increment: 100E-12
*RST: 0
Default unit: s
Usage: Query only
SEARch:RESult:DDR:FRAMe<m>:TYPE? <SearchName>
Returns the frame type for the selected frame number within the search result.
Suffix:
<m>
.
*
Query parameters:
<SearchName>
Return values:
<FrameType> READ | WRITe | RDNC | WRNC | UNKNown
RDNC: read data not continue
WRNC: write data not continue
*RST: UNKNown
Usage: Query only
22.17.24.5 Eye diagram analysis
The suffix EYE<m> selects the eye diagram to which the command applies. You can
configure and analyze up to four eye diagrams in parallel.
Basic setup
EYE<m>[:STATe]......................................................................................................... 2185
EYE<m>:SOURce........................................................................................................2185
EYE<m>:TREFerence[:SOURce]...................................................................................2185
EYE<m>:TREFerence:SLOPe.......................................................................................2185
EYE<m>:TREFerence:LEVel.........................................................................................2186
EYE<m>:HORizontal[:UNIT]..........................................................................................2186
EYE<m>:HORizontal:ABSolute:RANGe......................................................................... 2186
EYE<m>:HORizontal:ABSolute:POSition........................................................................2187
Protocols