Rohde & Schwarz RTP044 - Page 2221

Remote control commands
R&S
®
RTP
2221User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..2
Usage: Event
22.19.1.2 Function generator
WGENerator<m>:FUNCtion[:SELect].............................................................................2221
WGENerator<m>:FREQuency.......................................................................................2221
WGENerator<m>:PERiod............................................................................................. 2221
WGENerator<m>:FUNCtion:PULSe[:WIDTh].................................................................. 2222
WGENerator<m>:FUNCtion:RAMP[:SYMMetry]..............................................................2222
WGENerator<m>:FUNCtion:SQUare:DCYCle.................................................................2222
WGENerator<m>:FUNCtion[:SELect] <FunctionType>
Sets the type of waveform to be generated for the function generator.
Suffix:
<m>
.
1..2
Parameters:
<FunctionType> SINusoid | SQUare | RAMP | DC | PULSe | SINC | CARDiac |
GAUSs | LORNtz | EXPRise | EXPFall
SINC: Cardial sine
*RST: SINusoid
WGENerator<m>:FREQuency <Frequency>
Sets the frequency of the waveform. The available frequency range depends on the
selected function type.
Suffix:
<m>
.
1..2
Parameters:
<Frequency> Range: 1E-3 to 100E+6
Increment: 1
*RST: 1E+6
Default unit: Hz
WGENerator<m>:PERiod <Period>
Sets the period of the waveform. The available period range depends on the selected
function type.
Suffix:
<m>
.
1..2
Waveform generator (option R&S RTP-B6)