Rohde & Schwarz RTP044 - Page 2281

Remote control commands
R&S
®
RTP
2281User Manual 1337.9952.02 ─ 12
ADVJitter<m>:RESult:VERTical:BMTYpe <MeasType>
Selects the basic measurement type to apply the vertical scale to.
Suffix:
<m>
.
1..2
Parameters:
<MeasType> SBRate | SBDuration
SBRate: Symbol rate
SBDuration: Symbol duration
*RST: SBRate
ADVJitter<m>:RESult:VERTical:BHContinuous
<State>
If enabled, the measurement scale of the basic jitter measurement histogram and track
is set automatically.
If disabled you can manually set a ADVJitter<m>:RESult:COMPonents<n>:
SCALe and a ADVJitter<m>:RESult:COMPonents<n>:OFFSet.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
ADVJitter<m>:RESult:VERTical:JSContinuous <State>
If enabled, the measurement scale of the jitter spectrum is set automatically.
If disabled you can manually set a ADVJitter<m>:RESult:COMPonents<n>:
SCALe and a ADVJitter<m>:RESult:COMPonents<n>:OFFSet.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
ADVJitter<m>:RESult:VERTical:NHContinuous <State>
If enabled, the measurement scale of the noise histogram and track is set automati-
cally.
If disabled you can manually set a ADVJitter<m>:RESult:COMPonents<n>:
SCALe and a ADVJitter<m>:RESult:COMPonents<n>:OFFSet.
Suffix:
<m>
.
1..2
Jitter analysis and clock data recovery