Measurements
R&S
®
RTP
322User Manual 1337.9952.02 ─ 12
The complete configuration of cursor measurements is provided in the "Cursors" dialog
box.
► You can adjust the basic settings of an active cursor measurement in the sidebar:
cursor type, source, positions, and track. To open the sidebar, tap the icon in
the result box.
1. To open the "Cursors" dialog box, use one of these ways:
● Open the "Menu", and select the "Cursor" menu.
● Press the [Cursor] key.
●
Tap the
icon in the result box.
● On thetoolbar assist, tap "Advanced Setup".
2. Select the "Setup" tab.
3. Select the subtab for the cursor set that you want to use.
4. Tap the source icon, and select the measured waveform. You can select any input
channel, or various other active waveforms. Available sources are shown in the
source list.
5. If necessary, enable and select a 2nd waveform.
Cursor measurements
To Next Page
Loading...
