Measurements
R&S
®
RTP
332User Manual 1337.9952.02 ─ 12
8.2.1.1 Starting an automatic measurement
There are three methods to start an automatic measurement, each with slightly differ-
ent effects:
●
Using the "Measure" icon on the toolbar:
See: "To start a measurement using the toolbar icon" on page 332.
●
Pressing the [Meas] key on the front panel.
See: "To start a measurement with the [Meas] key" on page 332.
●
Using the "Measure" menu.
See: Chapter 8.2.1.2, "Configuring measurements", on page 332.
To start a measurement using the toolbar icon
1. Tap the "Measurement" icon on the toolbar.
2. On the toolbar assist, select the category, the measurements and the source to be
measured.
3. Define the measurement range in one of these ways:
● To measure the complete waveform, tap the diagram with the waveform.
● To define a gate that limits the measurement, draw a rectangle on the screen.
The "Meas Results" are displayed.
To start a measurement with the [Meas] key
1. Select the waveform on the screen.
2. Press the [Meas] key.
The measurement for the selected waveform is enabled using the next available
measurement configuration. The "Meas Results" are displayed.
8.2.1.2 Configuring measurements
1. To open the "Measurements" dialog box, choose one of these ways:
● If a measurement is already running, tap the result table. Then press the
[Meas] key.
● If no measurement is running, open the menu and select "Measure".
If you double-tap the title of a result table, the toolbar assist opens. Here you can
change the measurement types and enable statistics. If you tap "Advanced Setup"
in the toolbar assist, the "Measurements" dialog box opens.
2. Select the subtab for the measurement group that you want to configure.
Automatic measurements
To Next Page
Loading...
