Measurements
R&S
®
RTP
334User Manual 1337.9952.02 ─ 12
9. To compile and display statistics for the measurement, enable "Statistics". See also
Chapter 8.2.11.1, "Statistics", on page 388.
10. Optionally, perform a limit or margin check as described in Chapter 8.2.12.1, "Per-
forming limit checks", on page 396.
11. "Enable" the measurement group.
The measurement results are displayed by default below the waveform diagram.
8.2.1.3 General measurement settings
Automatic measurements are configured in the "Measurements" dialog box.
Access: [Meas] > "Meas Group" tab
This section describes the settings that relate to all measurements. Specific settings
are described in the corresponding category chapters:
●
Chapter 8.2.5.2, "Settings for amplitude/time measurements", on page 357
●
Chapter 18.1, "Jitter measurements (Option R&S RTP-K12)", on page 1013
●
Chapter 8.2.6.2, "Settings for eye diagram measurements", on page 368
●
Chapter 8.2.7.2, "Settings for spectrum measurements", on page 370
●
Chapter 8.2.8.5, "Settings for histogram measurement", on page 380
MG 1/2/3/4/5/6/7/8/Quick Meas
Subtabs for each measurement group, and for the quick measurement. The subtabs
contain the configuration settings. A green dot on the tab indicates that the measure-
ment group is active.
Automatic measurements
To Next Page
Loading...
