Mask testing
R&S
®
RTP
429User Manual 1337.9952.02 ─ 12
Alternatively, you can set the corner points on the touch screen and adjust the values
in the "Mask Definition" tab.
To save the mask, select the "Define Mask" tab and save the mask test.
Make sure that the correct "Mask Test" tab is selected on the left side before you enter
the settings.
Mask segments
Defines the number and state of mask segments for the selected mask test. Here you
can:
●
Insert a new segment before the selected segment.
●
Append a new segment at the end of the list.
●
Remove the selected mask segment from the list.
●
Select the region that builds the mask.
– Inner region: the segment points form a closed geometrical shape, which is the
mask segment.
– Upper region: the segment points are connected to a line, the display area
above this line is the mask segment.
– Lower region: the segment points are connected to a line, the display area
below this line is the mask segment.
●
Enable and disable the mask segments individually. Disabled segments are not
considered by running tests.
Remote command:
MTESt:SEGMent:STATe on page 1464
MTESt:SEGMent:ADD on page 1464
MTESt:SEGMent:REMove on page 1465
MTESt:SEGMent:INSert on page 1464
Mask test settings
To Next Page
Loading...
