Data and file management
R&S
®
RTP
491User Manual 1337.9952.02 ─ 12
".bin/.xml/.csv"
Selects the file format. Note that reference waveforms can be loaded
from .bin files only.
See also: Chapter 12.2.1, "Waveform export files", on page 481.
Remote command:
EXPort:WAVeform:NAME on page 1530
EXPort:WAVeform:SAVE on page 1530
12.2.2.2 Waveform history settings
Access: "Menu" key >"Save/Recall" key > "Save" tab > "Waveform" > "History" tab.
In this dialog you can configure the export of the history waveform data to file. Select
the channels and scope in the "Setup" tab.
Export history
Enables the history mode and the export of history waveforms to file.
Remote command:
CHANnel<m>[:WAVeform<n>]:HISTory[:STATe] on page 1341
Time stamps
If enabled, the relative timestamps of all history waveforms are written into the wave-
form data file at the beginning of each waveform record.
The following format is used:
<timestamp as double float of first acquisition>
<value 1>
<value 2>
<...>
<timestamp as double float of second acquisition>
<value 1>
<value 2>
<...>
Save and recall waveform data and results
To Next Page
Loading...
