Rohde & Schwarz RTP044 - Page 1530

Remote control commands
R&S
®
RTP
1530User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<ExportState> ON | OFF
If you enable the multichannel export, the export state of all
active channels is automatically set ON.
*RST: OFF
Usage: Asynchronous command
EXPort:WAVeform:NAME
<FileName>
Sets the file name, file format and path to save the waveform to.
See also: Chapter 12.2.1, "Waveform export files", on page 481
Parameters:
<FileName> String with path and file name with extension .xml, .bin, or .csv
Example:
EXPort:WAVeform:NAME 'C:\temp\Export_Chl1.xml'
EXPort:WAVeform:SAVE
Saves the waveform data in XML format to
C:\temp\Export_Ch1.xml.
Example:
EXPort:WAVeform:NAME 'C:\temp\Export_Ch2.bin'
EXPort:WAVeform:SAVE
Saves the waveform data in binary format to
C:\temp\Export_Ch2.bin.
Usage: Asynchronous command
EXPort:WAVeform:SAVE
Saves the waveform(s) to the file specified with EXPort:WAVeform:NAME. The file
format is also set using the ...NAME command.
Example:
See Chapter 22.3.5.2, "Exporting waveform data to file",
on page 1133
Usage: Event
EXPort:WAVeform:SCOPe <Scope>
Defines the part of the waveform record that has to be stored.
Parameters:
<Scope> WFM | ZOOM | CURSor | GATE | MANual
WFM
Complete waveform
Data management