Remote control commands
R&S
®
RTP
1531User Manual 1337.9952.02 ─ 12
ZOOM
Data included in the zoom area if a zoom is defined for the
source waveform.
CURSor
Data between the cursor lines if a cursor measurement is
defined for the source waveform.
GATE
data included in the measurement gate if a gated measurement
is defined for the source waveform.
MANual
Saves the data between user-defined start and stop values to be
set with EXPort:WAVeform:STARt and EXPort:WAVeform:
STOP.
*RST:
WFM
Example: See Chapter 22.3.5.2, "Exporting waveform data to file",
on page 1133
Usage: Asynchronous command
EXPort:WAVeform:STARt <Start>
Sets the start value of the waveform section for export, if EXPort:WAVeform:SCOPe
is set to Manual.
Parameters:
<Start> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Default unit: s
Usage: Asynchronous command
EXPort:WAVeform:STOP <Stop>
Sets the end value of the waveform section for export, if EXPort:WAVeform:SCOPe
is set to Manual.
Parameters:
<Stop> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Default unit: s
Usage: Asynchronous command
EXPort:WAVeform:ZOOM <ZoomDiagram>
Sets the zoom area to be used for limited data export if EXPort:WAVeform:SCOPe is
set to ZOOM.
Data management
To Next Page
Loading...
