Protocol analysis
R&S
®
RTP
530User Manual 1337.9952.02 ─ 12
Defines the bit pattern of the secondary device address. The length of the entry is
adjusted to the selected address type.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see Chapter 13.1.7, "Bit pattern editor",
on page 519.
"Condition"
Sets the comparison condition to a specific value or a range.
"Min"
Specifies the value or sets the start value of a range.
"Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:I2C:ADDRess on page 1559
TRIGger<m>:I2C:ADDTo on page 1559
TRIGger<m>:I2C:ADOR<n>[:VALue] on page 1560
R/W bit
Toggles the trigger condition between read and write access of the primary. Select
"Either" if the transfer direction is not relevant for the trigger condition.
Remote command:
TRIGger<m>:I2C:ACCess on page 1557
TRIGger<m>:I2C:ADOR<n>:RWBit on page 1560
OR x
Enables each selected condition, for "Trigger Type" = "Address OR".
Remote command:
TRIGger<m>:I2C:ADOR<n>:ENABle on page 1559
Position
Sets the number of data bytes to be skipped after the address. You can define an exact
position, or a position range. The index 0 is associated with the first data byte.
"Condition"
Sets the comparison condition to a specific value or a range.
"Index min"
Specifies the value or sets the start value of a range.
" Index max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:I2C:DPOPerator on page 1561
TRIGger<m>:I2C:DPOSition on page 1561
TRIGger<m>:I2C:DPTO on page 1561
Data
Specifies the trigger conditions for the data bit pattern.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see Chapter 13.1.7, "Bit pattern editor",
on page 519.
"Condition"
Sets the comparison condition to a specific value or a range.
I²C (option R&S RTP-K1)
To Next Page
Loading...
