Protocol analysis
R&S
®
RTP
581User Manual 1337.9952.02 ─ 12
Signal
Sets the signal name to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same signal if symbolic trigger and symbolic search is used at
the same time.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:SIGValue on page 1655
Condition
Sets the operator to set a specific data pattern or symbolic value ("Equal" or "Not
equal") or a data range.
This condition is also used to search for data, see "Data setup: DLC, NDB, Condition,
Data min, Data max" on page 575.
Remote command:
SEARch:TRIGger:CAN:DCONdition on page 1640
Value, Value (min)
Defines the data pattern or selects a symbolic data value.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:DMIN on page 1656
SEARch:TRIGger:CAN:SYMBolic:SGEValue on page 1656
Value (max)
The second data pattern is required to specify a range with conditions "In range" and
"Out of range".
Remote command:
SEARch:TRIGger:CAN:SYMBolic:DMAX on page 1656
13.5.6.4 Symbolic search results
If a DBC file is applied, you can search for symbolic messages and signals as descri-
bed in Chapter 13.5.6.3, "Symbolic search", on page 579. As ususal, the search results
are shown in a table. You can enable the search zoom window to view the frame with
the selected result in more detail.
The figure shows the result of a search for an "EngineData" message and the signal
"IdleRunning = Running" inside the message. The result marker (blue line) is set to the
start of the frame that fulfills the search condition. The search zoom window Search1 is
active. It has been moved to the right until the "IdleRunning" bit with value 0 is visible in
the zoom.
Remote command:
●
SEARch:RESult:CAN:FRAMe<m>:SDATa? on page 1654
CAN and CAN FD (option R&S
RTP-K3/K9)
To Next Page
Loading...
