Protocol analysis
R&S
®
RTP
584User Manual 1337.9952.02 ─ 12
Make sure that the tab of the correct serial bus is selected.
See also: Chapter 13.1.1, "Setup - general settings", on page 512
LIN standard
Selects the version of the LIN standard that is used in the DUT. The setting mainly
defines the checksum version used during decoding.
The most common version is LIN 2.x. For mixed networks, or if the standard is
unknown, set the LIN standard to "Auto".
Remote command:
BUS<m>:LIN:STANdard on page 1659
Data
Sets the source waveform of the data line.
Usually, the source is one of the analog channels. Reference and math waveforms are
available as source if the trigger source is one of the analog channels but not the serial
bus.
Alternatively, digital channels can be used if MSO option R&S RTP-B1 is installed. Dig-
ital and analog channels cannot be used at the same time.
For triggering on a serial bus, analog or digital channel sources are required.
Remote command:
BUS<m>:LIN:DATA:SOURce on page 1657
LIN (option R&S
RTP-K3)
To Next Page
Loading...
