Protocol analysis
R&S
®
RTP
646User Manual 1337.9952.02 ─ 12
Symbol rate
Defines the transmission rate of ternary symbols which is by default 66.67 MSymb/s.
This parameter should be rarely changed.
Remote command:
BUS<m>:HBTO:SYMRate on page 1754
Autoset
Starts software algorithms for determining the signal threshold levels and bitrate.
Remote command:
BUS<m>:FAUToset on page 1549
13.10.2.3 100BASE-T1 display settings
Access: [Protocol] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 514.
To enhance the decode possibilities of the 100BASE-T1 protocol, you can use an addi-
tional setting in the "Display" tab: "Decode layer".
Ethernet 100BASE-T1 (option R&S RTP-57)
To Next Page
Loading...
