Rohde & Schwarz RTP044 - Page 663

Protocol analysis
R&S
®
RTP
663User Manual 1337.9952.02 ─ 12
Remote command:
BUS<m>:FAUToset on page 1549
13.11.2.2 1000BASE-T1 display settings
Access: [Protocol] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 514.
To enhance the decode possibilities of the 1000BASE-T1 protocol, you can use an
additional setting in the "Display" tab: "Decode layer".
1000BASE-T1 Specific Label Settings
Label lists are protocol-specific. Label lists for 1000BASE-T1 are available in CSV and
PTT format.
A 1000BASE-T1 label file contains two values for each ethernet header:
●
Ethernet header display
●
Symbolic label: name of the address, specifiing its function in the bus network.
Decode layer
Selects the decode layer.
Ethernet 1000BASE-T1 (option R&S
RTP-K58)