EasyManua.ls Logo

Rohde & Schwarz RTP044 - Page 713

Rohde & Schwarz RTP044
2403 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protocol analysis
R&S
®
RTP
713User Manual 1337.9952.02 ─ 12
"Data Max"
The second data value pattern is required to specify a range with
conditions "In range" and "Out of range".
Remote command:
For "Type">"HS Data":
SEARch:TRIGger:DPHY:DATA:CONDition on page 1862
SEARch:TRIGger:DPHY:DATA:MAX on page 1862
SEARch:TRIGger:DPHY:DATA:MIN on page 1862
For "Type">"LP Escape Mode":
SEARch:TRIGger:DPHY:ESDTa:CONDition on page 1866
SEARch:TRIGger:DPHY:ESDTa:MAX on page 1866
SEARch:TRIGger:DPHY:ESDTa:MIN on page 1866
Data Index
Data index sets the range within this series of the data value to be searched for. The
data index setup consists of the condition and one or two data index values.
"Condition"
Defines the operator to set a specific data ("Equal") or a data range.
"Index Min/Index"
Defines the minimum index.
"Index Max"
The second index pattern is required to specify a range with condi-
tions "In range".
Remote command:
For "Type">"HS Data":
SEARch:TRIGger:DPHY:DIDX:CONDition on page 1863
SEARch:TRIGger:DPHY:DIDX:MAX on page 1863
SEARch:TRIGger:DPHY:DIDX:MIN on page 1863
For "Type">"LP Escape Mode":
SEARch:TRIGger:DPHY:ESINdex:CONDition on page 1867
SEARch:TRIGger:DPHY:ESINdex:MAX on page 1867
SEARch:TRIGger:DPHY:ESINdex:MIN on page 1867
Escape mode
Searches for an escape mode event. The escape mode setup consists of the condition
and one or two data patterns.
"Condition"
Defines the operator to set a specific word count ("Equal" or "Not
equal") or a word count range.
"Data Min/Data"
Defines the bit pattern of the data pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
SEARch:TRIGger:DPHY:ESCMode:CONDition on page 1865
SEARch:TRIGger:DPHY:ESCMode:MAX on page 1865
SEARch:TRIGger:DPHY:ESCMode:MIN on page 1865
D-PHY (ption R&S
RTP-K42)

Table of Contents

Other manuals for Rohde & Schwarz RTP044

Related product manuals